Installation Manual
Low Voltage Wiring
Low Voltage Wiring Diagram
WARNING: Do not power the Harvest Pod, or 3rd Party Air Handler, until all wiring is complete and correct. Wiring the Harvest Pod incorrectly may damage it.
1
Remove the thumb screws at the bottom and top of the pod to remove the front panel of the Pod and access the wiring connections.
2
To make internal wiring connections, push wires through the "hamster tube" from the underside of the pod.
3
Wire the Pod. Follow the link below that best fits your installation scenario:
24VAC controlled heat pumps (Rheem, Ruud, Carrier, etc...)
Communicating heat pumps (Mitsubishi and Fujitsu)
Hydronic heating only (with or without AC)