Thermal Battery System Start Up

system commissioning with the harvest tech app power on the harvest pod connect your phone/tablet/laptop to the harvest pod's wifi access point the network name (harvestpodxxxx) and password can be found on the label on the bottom of the pod wait at least 5 minutes after powering the pod before attempting to access the harvest tech app navigate to "http //harvestpodxxxx local" using an internet browser, where "xxxx" is the same as the name of the network setup the pod confirm you have installed the sanco2 heat pump and the tank choose "radiant" for installation type choose "radiant" for system type 5 if not already connected using ethernet, connect the pod to the home's internet by selecting the correct wifi network and entering the password the initial connection may take a few minutes to confirm 6 save and continue to customer profile fill in the customer profile save and continue to hardware once complete select the appropriate installed hardware the generation can be found in the model number shown on the nameplate of the sanco2 "number of heat pumps" refers to the number of sanco2 heat pump water heaters installed f3 and t6 are optional sensors included in the harvest sensor kit check sensors and thermostat for proper function test that heat, cool, fan, and off thermostat calls are reflected in the "thermostat check" to validate the thermostat wiring ensure all listed sensors are indicated as "ok", and troubleshoot any external sensors that are not test the sanco2 wiring select "enable manual control" toggle the sanco2 on the sanco2 should turn on, and the power draw should read over 500 w this will take 3 5 minutes test the hydronic circulator pump to ensure it is fully purged of air ensure manual control is enabled enter 40 and select "start" the circulator pump inside of the pod should turn on, and the app should display flow after 1 2 minutes if no flow is displayed, check that the loop is fully purged and that all valves are open note particularly long pipe runs may require a higher pump speed to produce flow configure energy harvesting select time of use control select utility rate schedule based on customers' current or requested utility rate select "ecoport is integrated into the pod "